Right-click any frame, and choose Decode as. Remember the raw-pcap ID so that you can stop the remote packet capture.ģ) You should be seeing some traffic arriving at your Wireshark. Note: 5000 is the port you chose in step 1, and "1" is the Airopeek format. Choose Airopeek format for the remote packet capture. Click Start.Ģ) On the controller, start the raw packet capture from WebUI or CLI. Apply the capture filter as udp port 5000 or whatever port you want. Choose the wired port interface (en0 on Mac OSX, or eth0 on Linux). To configure the Wireshark for remote packet capture, follow these steps:ġ) Start Wireshark as usual. Product and Software : This article applies to all Aruba controllers and ArubaOS versions. Question: How do I configure the Wireshark for remote packet capture (on Windows, Mac OSX, and Linux)?
0 Comments
Leave a Reply. |